Scott S / 900 User Manual page 8

HT:
this is the no cable option
this is the cover plate
for all cable options
The inserts are marked A–E, these letters dictate what cables can be used; these are the
same for left and right.
A:
1x Mechanical cable 2x Mechanical cables
D:
1x single cable & Di2
Single cable and Live valve
If you wish to change or replace the headtube cableguide set on your SCOTT Genius this kit
can be ordered from your local SCOTT dealer.
SCOTT part number: 266587 and consists of:
2x HT/A/B/C/D
1x HT-Blank/E
| 14 ENGLISH
HT-Blank:
B: C:
2x mechanical cables
1x hydraulic
E:
GENIUS | BIKE USER MANUAL
These cable guides are fitted with a single bolt, the fixing torque of this must not exceed
0.75-1 N/M.
With the many different cabling options it is possible to customise the cable routing slightly
depending on what components you wish to run, it is recommended that handlebar cables
that come from the right hand side enter the frame on the left, and handlebar cables that
come from the left hand side enter the frame on the right, while this is not crucial to the
performance of the bike it may help to prevent any cable rub.
The diagram shows an example of a bike set up "European style" with a 1X set up and a
dropper seatpost.
Please note that this
diagram is an example
and that your bike's
brakes need to be set
up as per the law in
your country. Please
check with your local
SCOTT dealer for this
information.
On the underside of the
down tube the cables/
hoses will route through
the down tube cover.
Image is shown with
livewire and Di2 installed.
Shifter cable
Brake cable
Live valve
BIKE USER MANUAL | GENIUS
ENGLISH 15 |