Electrical Safety - Black & Decker SVA420B Manual

ENGLISH ENGLISH

Electrical safety

Symbols on the charger
Read all of this manual carefully before using
#
the appliance
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
$
Indication of polarity.
The charging base is intended for indoor use
only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
JOD-S-180050GS
JOD-S-180050GS
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust bowl release button
3. Dust bowl
4. Chassis on/off power switch
5. Brush control switch
6. Upper handle
7. Main chassis
7a. Chassis release button
8. Floor head
9. Floor charging base
9a. Tool storage
10. Charger
11. Brush tool accessory
12. Crevice tool accessory
8
8
(Original instructions)
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1) located on the
u
handle of the main unit (1), or alternatively on the chassis
handle (4).
To switch off, press the on/off switch (1) or (4).
u
Using Accessories (Fig. B)
The appliance is supplied with a brush tool (11) and a
u
crevice tool (12).
-
Fit the chosen accessory into the front of the appliance as
u
shown in Figure B.
Fitting the upper handle to the main chassis
(Fig. C, D)
The stick vac chassis is supplied in 2 parts, the upper han-
u
dle (6) and the lower chassis (7), but they are connected
by a wire.
Slide the upper handle (6) into the main chassis (7) as
u
Ensure the wire is not trapped.
u
u
(Fig. E)
u
Fitting the vacuum to the Chassis
(Fig. F, G)
u
To release the vacuum from the chassis press the chassis
u
release button (7a) and lift clear.
The appliance can now be operated via the on/off button
u
(4) on the handle (6). This also allows you to utilise the
beater bars via the 'brush on' control (5) as shown in
Charging (Fig. H)
The charging base (9) will need to be securely fastened to
u
a wall.
Note:
surface are used.
Place the appliance into the charging base (9) as shown in
u
.
Plug the charger (10) into the charging base (9)
u
Plug the charger (10) into an electrical outlet.
u
Switch the electrical outlet on. The LED charging indicator
u
(14) will illuminate (Fig. I).