Electrical Safety; Symbols On The Charger - Black & Decker BHSB320JP Manual

able batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the volt-
age on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.

Symbols on the charger

Read all of this manual carefully
before using the appliance.
This tool is double insulated;
#
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Use with charger S010QC1400040
S010QC1400040
(Original instructions)
Read all of this manual carefully before
using the appliance
Features
This tool includes some or all of the following features.
1. Fluid dispenser trigger
2. Vacuum ON/OFF button / beater bar ON button
3. Removable fluid tank
4. Spray nozzle
5. Removable chute
6. Collection tank release button
7. Collection tank
8. Power brush (BHSB320JP)
9. LED indicator
9a. State of charge button
Charging the battery (Fig. A)
Ensure unit is not switched on.
u
Plug wall adapter into outlet.
u
Plug connector (11) into charging port (10) at the back of
u
the handle.
The LED light (9) at the back of the handle will light while
u
charging.
The LED light (9) will turn off upon completion of charge.
u
Product is not operational while plugged in to charger.
u
Both these appliances include a state of charge indicator
which consists of three white LED lights (9a) that indicate the
approximate level of charge remaining in the battery.
To check the state of charge, press the state of charge
u
button (9a).
Note: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Switching ON and OFF (Fig. E)
To start the vacuum, slide the switch (2) forward to the
u
ON position.
To start the powered scrub brush (8), slide the switch (2)
u
forward to the scrub and vacuum position.
To stop the vacuum and scrub brush, return the switch to
u
the OFF position.
Return the product to the charger immediately after
u
use so that it will be ready and fully charged for the next
use. Ensure that the plug connector is fully inserted into
the charging port.
Vacuuming dry and wet spills
Wet and dry pick-up
This unit can be used to pick up everyday dry, wet
u
or liquid spills.
ENGLISH
11