Advertisement
Available languages
Available languages
the specific guard designed for the
selected wheel. Wheels for which the power
tool was not designed cannot be adequately
guarded and are unsafe.
b)
The guard must be securely attached to
the power tool and positioned for
maximum safety, so the least amount of
wheel is exposed towards the operator.
The guard helps to protect the operator from
broken wheel fragments, accidental contact
with wheel and sparks that could ignite
clothing.
c)
Wheels must be used only for
recommended applications. For example:
do not grind with the side of cut-off
wheel. Abrasive cut-off wheels are intended
for peripheral grinding, side forces applied to
these wheels may cause them to shatter.
d)
Always use undamaged wheel flanges
that are of correct size and shape for
your selected wheel. Proper wheel flanges
support the wheel thus reducing the
possibility of wheel breakage. Flanges for
cut-off wheels may be different from grinding
wheel flanges.
e)
Do not use worn down wheels from larger
power tools. Wheel intended for larger
power tool is not suitable for the higher
speed of a smaller tool and may burst.
Additional Safety Information
Do not use Type 11 (flaring cup) wheels
on this tool. Using inappropriate accessories
can result in injury.
Air vents often cover moving parts and
should be avoided. Loose clothes, jewelry
or long hair can be caught in moving parts.
Avoid prolonged contact with dust from
power sanding, sawing, grinding, drilling,
and other construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing dust
to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful
chemicals.
WARNING: When not in use, place grinder
on a stable surface where it will not move
inadvertantly, roll or cause a tripping or
falling hazard. Serious personal injury may
result.
CAUTION: To reduce the risk of personal
injury, use extra care when working into a
corner or edge because a sudden, sharp
movement of the tool may be experienced
when the wheel or other accessory contacts
a secondary surface or a surface edge.
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
...............alternating current
...........direct current
...............alternating or direct current
................Class I Construction
n o ................no load speed
....................(grounded)
................earthing terminal
................Class II Construction
.................safety alert symbol
....................(double insulated)
BPM ............beats per minute
r/min ...........
revolutions
RPM ............revolutions
IPM ..............impacts per minute
sfpm ............surface feet per minute
EN GL ISH
per minute
per minute
5
Advertisement
