Table Mounting The Chassis - Alcatel OS6855-24 Hardware User's Manual

Mounting OS6855-24 and OS6855-U24/U24X

Table Mounting the Chassis

OmniSwitch 6855 Series switches can be installed freestanding as a tabletop unit.
Note. Be sure that adequate clearance has been provided for chassis air flow and access to the front, back,
and sides of the switch. For recommended clearances, refer to
page 3-1. Also, be sure that you have placed the chassis within the reach of all the required AC power
sources.
To install the switch as a tabletop unit, follow the steps below:
1
Secure the power supply tray and power supplies to the back of the chassis as described on
2
Using the attachment screws supplied with your switch, attach the mounting brackets to the front
portion of the chassis. Attach the brackets to both the left and right side of the switch. Be sure that the flat
portion of each bracket is facing down. (refer to illustration below).
MOUNTING BRACKET
3
Using the attachment screws supplied with your switch, attach the mounting brackets to the rear
portion of the chassis. Attach the brackets to both the left and right side of the switch. Be sure that the flat
portion of each bracket is facing down. (refer to illustration below).
REAR OF
SWITCH
MOUNTING BRACKET
OmniSwitch 6855 Series Hardware Users Guide
"General Mounting Recommendations" on
SWITCH CHASSIS
September 2011
Table Mounting the Chassis
page 3-6.
page 3-15