Readjustment V-Beltplacing Oil Filter; Air Strainer Element; Regular Maintenance - Whisper Power W-SQ6 User Manual

Mobile diesel generating set 230v / 50hz, digital diesel control
Hide thumbs Also See for W-SQ6:
Table of Contents

Advertisement

MAINTENANCE
A smeer of oil has to be put on the seal of the filter before
fitting the filter. The filter should be fastened manually:
when the rubber touches the metal turn 3/4 further.
Fig. 21
4.2.6

Readjustment V-beltplacing oil filter

The alternator bracket allows for readjust of the V-belt.
Deflections should be 10 mm (refer to fig. 22)
Fig. 22
4.2.7

Air strainer element

The W-SQ6 for mobile applications is standard supplied
with an air strainer element (figure 23). Strainer change
depends on environmental contamination. Check the air
strainer at least every 500 running hours. The strainer can
be cleaned by washing in petrol or solvent
Fig. 23
26
4.3
CHECK DAILY:
Take care the oil level is never
below the mark. Do not add oil
when the level is still above
the mark
1
Minimum oil level
2
Maximum oil level
Fig. 24:
CHECK DAILY:
AFTER FIRST 50 HOURS:
10 mm
EVERY 150 HOURS:

REGULAR MAINTENANCE

Oil level (see fig. 24)
Level cooling liquid
Hoses for loose connections or deterioration.
Change oil and replace the oil filter.
Have the engine run until it is on temperature and
stop it. Replace the oil filter. Drain oil by the sump
pump into a suitable retainer and fill up with fresh
oil. Start the engine again and have it run for 5
minutes. Stop the engine again and pause for a
few minutes to let the oil gather in the crankcase.
Check the level again and add oil when
necessary.
Check and tighten nuts, bolts, and unions, paying
particular attention to the fuel system.
Observe the exhaust at the normal full load. The
exhaust must be free from soot. Do not allow the
engine to run with a dirty exhaust without
investigating the cause as this may result in an
expensive breakdown.
Check and readjust V-belt.
Check the electrical connections.
Change oil.
Check the battery acid level (not applicable when
Whisper Power batteries are used).
Check battery terminals for corrosion
Check and readjust V-belt
October 2008 / W-SQ6 for mobile applications / EN
1
2

Advertisement

Table of Contents
loading

Table of Contents