Technical Specifications - PEP Modular Computers CP331 Manual

CP331

1.4 Technical Specifications

Table 1-2: Technical Specifications (Sheet 1 of 2)
CP331
CompactPCI Interface
VGA Resoutions
Flatpanel Types
Connectors
Video Memory
BIOS Memory
Driver Support
Mechanical Compliance
ID 19947, Rev. 0200
• PICMG 2.0 Rev. 2.1 compliant September 2, 1997,
connected to J1
• 32 bit bus address/data / 33MHz
• CompactPCI data burst rate approximately 132 MByte/s
• Universal signaling voltage (3.3V, to fit in 3.3V or 5V bus)
• C&T 69000+C&T 69030
• C&T 69000+C&T 69030
• C&T 69000+C&T 69030
• C&T 69000+C&T 69030
• C&T 69030
TFT, DSTN, SSTN, EL, Plasma
• CRT front-end connector (15-pin VGA)
• LVDS connector (26-pin miniature Delta
Ribbon)
• PanelLink connector (20-pin miniature Delta
Ribbon)
• Flatpanel adapter connector CON8
(64-pin on-board pin-row connector)
• Internal TTL flatpanel connector CON9
(on-board 40-pin on-board pin-row connector)
• General-purpose connector CON10
(8-pin on-board pin-row connector)
• CompactPCI bus connector J1
• CompactPCI rear I/O connector J2
• C&T 69000:
• C&T 69030:
64kB for Video BIOS
Windows NT 4.0, Windows 2000
IEEE 1101.10
© 2000 PEP Modular Computers GmbH
Introduction
Specification
1280 x 1024 x 8 at 60, 75, 85 Hz
(85Hz interlaced)
1024 x 768 x 16 at 60, 75, 85 Hz
(85Hz interlaced)
800 x 600 x 24 at 60, 75, 85 Hz
(85Hz interlaced)
640 x 480 x 24 at 60, 75, 85 Hz
(85Hz interlaced)
1600 x 1200 x 16 at 60 Hz
all board variants
CP331-LVDS
CP331-PL
CP331,
CP331-PL
CP331,
CP331-PL
CP331-LVDS
all board variants
on request
2MB
4MB
Page 1 - 11