Maintenance - Husqvarna LP 6500 I Operator's Manual

a) Turn the ignition key to the stop position.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control and the control for forward
and rearward movement for damage.
Make sure that the throttle control and the control for for-
ward and rearward movement can move smoothly.
Lubricate the controls and linkages.
Examine the safety straps for damage. Replace if it is
necessary.
Examine the vibration damping units for damage.
Make sure that the scrapers do not touch the drums. Ad-
just the clearance if it is necessary.
Fill the water tank with clean water.
Examine all rubber hoses and rubber elements for dam-
age. Replace if it is necessary.
Do a check of the hydraulic oil level.
Do a check of the battery.
Replace the oil in the eccentric element.
Examine and clean the hydraulic oil cooler.
1503 - 001 - 12.11.2020
b) Remove the ignition key to prevent accidental
start.

Maintenance

X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Before use,
each 10 h
*
X
*
*
*
*
X
X
X
*
X
X
Weekly, Monthly,
each 100 h each 250 h
X
X
O
Yearly, each
500 h
X
X
X
11