Maintenance - Husqvarna LF 75 Operator's Manual

a) To turn the product with a minimum turning
radius, lift the handle to a 90 degrees angle. Use
this function in small spaces and on ground that
is not level.
To set the product in operation position
1. Loosen the handle knobs (A).
B
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
945 - 003 - 03.04.2020
A

Maintenance

2. Lift the handle (B).
3. Tighten the handle knobs (A).
To set the product in transport position
1. Loosen the handle knobs (A).
2. Lower the handle (B).
3. Tighten the handle knobs (A).
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
B
A
13