Husqvarna LP 6500 I Operator's Manual page 10

1. Make sure that the vibration control (A) is in the OFF
position.
A
B
2. Make sure that the control for forward and rearward
movement (B) is in the neutral position.
3. Set the battery switch in the ON position.
4. Turn the ignition key to the ignition position.
a) When the engine starts, immediately release the
ignition key. The ignition key goes to the neutral
position.
b) If the engine does not start in 20 seconds,
release the ignition key and wait 60 seconds
before you try again.
10
5. Let the engine operate at idle speed for 2–3 minutes.
To operate the product
• To operate the product forward, move the control for
forward and rearward movement (B) forward.
A
B
• To operate the product rearward, move the control
for forward and rearward movement (B) rearward.
• To start the vibration, move the vibration control (A)
to the ON position.
• To stop the movement of the product, release the
control for forward and rearward movement.
• To stop the movement of the product in an
emergency, push the emergency stop button (C).
Note: The movement stops also if the control for
forward and rearward movement is in the forward or
rearward position.
To stop the product
1. Park the product on level ground.
2. Press the stop lever to stop the engine.
3. If the engine has an electrical start, also do these
steps:
C
1503 - 001 - 12.11.2020