Husqvarna LP 6500 I Operator's Manual page 15

8. Fill the eccentric element with oil until the oil starts to
come out of the hole for the oil level plug (C). Refer
Technical data on page 18 for correct quantity
to
and type of oil.
9. Install the oil level plug (C).
10. Install the oil fill plug (B).
To replace the fuel filter
WARNING: Use protective gloves to prevent
skin irritation. Fuel can come from the fuel
filter and onto your skin.
1. Disconnect the hoses from the fuel filter.
2. Install a new fuel filter.
Refer to the engine manual for more information.
To do a check of the battery
1. Disconnect the battery cables.
2. Examine the battery for damages. Replace the
battery if it is damaged.
3. Clean the battery terminals and the battery cable
connectors.
4. Lubricate the battery terminals and the battery cable
connectors with grease that does not contain acid.
5. Connect the battery cables.
6. Make sure that the battery is correctly attached.
To charge the battery
• If the battery is not used for a long period of time,
charge it fully before you use it.
• Use a battery charger that automatically adjusts the
voltage. We recommend a 2-stage charger with
constant voltage that automatically decreases to
trickle charging when the battery is fully charged.
Speak to your Husqvarna dealer for information
about the correct battery charger.
• Do a trickle charging 1-2 times during the winter
season when the product is in storage.
1503 - 001 - 12.11.2020
Hydraulic system
To do a check of the hydraulic hoses
• Examine the hydraulic hoses regularly. Replace
worn or damaged hydraulic hoses.
WARNING: Hydraulic oil is dangerous. The
rubber in the hydraulic hoses wears with
time. Worn or damaged hydraulic hoses can
break and the hydraulic oil can cause injury.
If you cannot tell if the hydraulic hoses are
worn, always replace the hydraulic hoses.
To do a check of the hydraulic oil level
1. Read the hydraulic oil level in the sight glass on the
hydraulic oil tank.
A
2. If the hydraulic oil level is too low, fill hydraulic oil
into the tank (A).
To replace the hydraulic oil
WARNING: There is a risk of burn injury.
The hydraulic oil becomes hot during
operation of the product. Let the product
become cool before you replace the
hydraulic oil.
1. Remove the oil tank cap with the bleeder filter (A).
A
B
15