Husqvarna LP 6500 I Operator's Manual page 12

General product maintenance
Replace the hydraulic oil.
Engine maintenance
Do a check of the fuel level and the engine oil level.
Clean the cooling system of the engine.
Clean the air filter if it is necessary.
Replace the air filter.
Do a check of the water separator. Drain the water sepa-
rator if it is necessary.
Replace the engine oil.
Drain and clean the fuel tank and replace the fuel filter.
Adjust the valve head clearance for the air intake and the
exhaust valves.
Replace the oil filter.
Do a check of the fuel injection pump.
Do a check of the fuel injection nozzle.
Drain water from the fuel system.
To clean the product
CAUTION: Before you clean the product,
attach a plastic bag tightly around the fuel
tank cap. This is to make sure that water
does not go into the venthole in the fuel tank
cap.
• Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION: Do not point the water
directly at the fuel tank cap, electrical
components or the engine.
• Remove grease and oil from the handle.
12
Before use, Weekly,
each 10 h each 100 h
Before use, After the
each 10 h first 20 h
X
O
X X
X
X
O
O
To do a check of the scrapers
1. Make sure that the scraper blades (A) do not touch
the drums.
2. If it is necessary, adjust the screws (B) until the
clearance (C) is 1.5 mm/0.06 in.
Monthly, Yearly, each
each 250 h 500 h
X
Yearly, each
Each 250 h
500 h
O O
X X
X X
O
O O
O O
O
O
O
B
C
A
1503 - 001 - 12.11.2020