L3Harris Narda SignalShark 3330 Quick Start And Safety Instructions page 67

4. Mount the sheathing (5) onto the RJ45 connector.
5. Slide the seal body (3) onto the sheathing (5).
6. Slide the coupler (6) over the RJ45 connector.
a. To do this, make sure that the notches in (3) and (5) are aligned.
b. Align the ridge in the coupler (6a) with the notch and slide the coupler
over the seal body fully.
7. Screw the end nut (1) onto the coupler (6) and tighten it hand-tight.
Connecting the RJ45 coupler to the Outdoor Unit
 The RJ45 coupler has been mounted on the connector of the patch
cable.
 The patch cable has been connected to the network hub.
 The network hub is ready for operation.
1. Plug the RJ45 coupler into the RJ45 socket on the device input.
 The device starts automatically when supplied with power.
2. Set up your network.
For network setup, Narda recommends the use of a travel router with
integrated modem. Detailed setup information can be found in the online
help of the Outdoor Unit.
Narda
SignalShark 3330 Outdoor Unit 67