Table of Contents
Advertisement
LIST OF CAUTION, NOTES, AND SYMBOLS USED IN THE SCHEMATIC DIAGRAMS ON THE FOLLOWING
PAGES:
1. CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE ONLY WITH THE SAME TYPE FUSE.
2. CAUTION:
Fixed Voltage (or Auto voltage selectable) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown, first check to see that all components in the power supply circuit are not defective
before you connect the AC plug to the AC power supply. Otherwise it may cause some components in the power
supply circuit to fail.
3. Note:
(1) Do not use the part number shown on the drawings for ordering. The correct part number is shown in the parts
list, and may be slightly different or amended since the drawings were prepared.
(2) To maintain original function and reliability of repaired units, use only original replacement parts which are listed
with their part numbers in the parts list section of the service manual.
4. Voltage indications for PLAY modes on the schematics are as shown below:
< DVD Section >
1
5.0
The same voltage for
both PLAY & STOP modes Indicates that the voltage
5. How to read converged lines
1-D3
Distinction Area
Line Number
(1 to 3 digits)
Examples:
1. "1-D3" means that line number "1" goes to area "D3".
2. "1-B1" means that line number "1" goes to area "B1".
6. Test Point Information
: Indicates a test point with a jumper wire across a hole in the PCB.
: Used to indicate a test point with a component lead on foil side.
: Used to indicate a test point with no test pin.
: Used to indicate a test point with a test pin.
PLAY mode
2
3
STOP mode
5.0
(2.5)
is not consistent here.
< VCR Section >
1
2
3
5.0
5.0
(2.5)
The same voltage for
< >
both PLAY, REC & DVD
Indicates that the voltage
modes
is not consistent here.
3
2
1
1-12-2
Unit: Volts
PLAY mode
REC mode
DVD mode
1-B1
AREA D3
AREA B1
1-D3
A
B
C
D
H9740SC
Advertisement
Table of Contents
