10.Press [CLEAR/C-RESET] button on the remote con-
trol unit.
Fig. h appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR
When "OK" appears on the screen, the factory
default will be set. Then the firmware renewal mode
is complete.
11.To exit this mode, press [OPERATE] button.
EXIT: POWER
Fig. h
1-9-2
H9740TEST
Need help?
Do you have a question about the DV-NC100S and is the answer not in the manual?
Questions and answers