Installing On Openserver; Installing On Unixware; Installing On Solaris - Adaptec 2258400-R Installation And User Manual

Installing on OpenServer

To install the driver on OpenServer:
Start your computer, then insert the driver disk.
1
Begin the driver package installer:
2
pkgadd -d diskette1
At the installer prompt, type
3
Select 1 for the aacraid package.
4
When the installation is complete, select q to quit the installer.
5
Reboot your computer and remove the driver disk.
6
Continue with
7

Installing on UnixWare

To install the driver on UnixWare:
Start your computer, then insert the driver disk.
1
Begin the driver package installer:
2
pkgadd -d diskette1
At the installer prompt, type
3
Select 1 for the aacraid package.
4
When the installation is complete, select q to quit the installer.
5
Reboot your computer and remove the driver disk.
6
Continue with
7

Installing on Solaris

To install the driver on Solaris:
Start your computer.
1
Check for any pre-existing Adaptec driver by performing a
2
window. If there is no pre-existing Adaptec driver on your computer, continue with
Step 3. If an Adaptec driver is already installed on your computer, perform a
to remove it.
SUNWaac
Caution:
!
reset your computer after you remove the pre-existing Adaptec driver. Instead, follow
the steps in this section to install a new driver before rebooting your computer.
Insert and mount the driver disk:
3
volcheck
Change to the driver installer directory:
4
cd /floppy/floppy0/DU/sol_210/i86pc/Tools
Chapter 8: Installing the Driver on an Existing Operating System
.
go
Managing Your Storage Space on page
.
go
Managing Your Storage Space on page
If your operating system currently boots from the Adaptec controller, do not
57.
57.
in a terminal
pkginfo SUNWaac
pkgrm
55
●