Table of Contents
Advertisement
Figure 2-2. ICP RAID Controller Layout GDT8586RZ
2.1.2
Installing the ICP RAID Controller
1. Power-off the computer system.
2. Disconnect power cord(s) and remove the system cover.
3. Install the ICP RAID controller into an available PCI slot. See
Use the appropriate bracket on the controller for your server platform.
Note:
4. Using SATA cables, connect the SATA drives to the internal SATA connectors located
on the ICP RAID Controller.
5. Replace the system cover and reconnect power cord(s).
Warning: Attention the controller CPU can get HOT! Controller requires constant airflow for
cooling (min 1m/sec).
LEDs on Reverse Side:
S
= On in Recovery Mode
red
T
= Internal Data Transfer
green
Sum = Activity on any Port
yellow
P66 = 66MHz PCI Clock
green
3V3 = 3.3 Volt available
green
5V = 5 Volt available
green
Per Port
Data= Activity per Port
yellow
Stat = Disk failed (if Auto Hot
red
Plug / Non-Int. Encl.
configured)
Do not use connectors that are
not mentioned
A0
A1
B0
LED Connectors for:
- SUM Activity
- Activity Port A0
B1
- Activity Port A1
- Activity Port B0
- Activity Port B1
- External Alarm
I²C Connectors for
SAFTE Backplanes
PCI bus speed
C0
Up = Auto (33/66MHz)
Low = Force 33MHz
C1
LED Connectors for:
- SUM Activity
- Activity Port C0
D0
- Activity Port C1
- Activity Port D0
- Activity Port D1
D1
- External Alarm
FRU Jumper
Right = Normal Mode
Left = Recovery Mode
Figure
2-3.
Advertisement
Table of Contents
