Adaptec 2256100-R Installation And User Manual page 48

Adaptec Flash Utility V1.0
(c)Adaptec Inc. 1999–2008. All Rights Reserved.
Updating Controller 0 (ASC-1045/1405)
Reading flash image file (Build 0018)
AFU is about to update BIOS on controller(s) Adaptec ASC-1045
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing ASC-1045/1405 Flash Image to controller 0...OK.
Please restart your computer for the new BIOS changes to take effect.
VERIFY
The command compares the contents of the flash components on a SATA/SAS
VERIFY
controller to the corresponding image in a UFI file, and determines whether the
controller's flash components are up-to-date.
Command Syntax
The command syntax for the
Controller ID
AFU VERIFY [/C<
Command Switches
For details on the /C and /D switches, see
Example
The below example shows a typical system response after a
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V1.0
(c)Adaptec Inc. 1999–2008. All Rights Reserved.
Reading flash image file (Build 0018)
Controller #0: ASC-1045/1405
File: Checksum: 642C [VALID] (Build 1406)
Verified Successfully
VERSION
The command displays the version information about the flash components on a
VERSION
SATA/SAS controller.
Command Syntax
The command syntax for the
Controller ID
AFU VERSION [/C<
Command Switches
For details on the /C switch, see
Example
The below example displays the version information about all supported SATA/SAS
controllers:
Appendix 10: Using the Adaptec Flash Utility for DOS
command is as follows:
VERIFY
UFI File Path
>] [/D <
SAVE on page
command is as follows:
VERSION
>]
SAVE on page 46.
SAS
>]
46.
command is performed:
VERIFY
48
●