Adaptec 2256100-R Installation And User Manual page 36

2
Now select Verify Disk Media and press <Enter>.
3
A confirmation window appears. Click Yes to verify the disk or No to cancel.
Locating a Disk
1
Select the disk you want to locate and press <Enter>.
2
Now select Indicate a LED and press <Enter>. The following options are displayed.
Blink LED on all drives - Use this option to blink on all drives to ensure that the drives are
●
working properly.
Blink LED on specific drive - Use this option to locate a specific drive.
●
Enabling/Disabling a Write Cache
1
Select the device/disk and press <Enter>.
2
Now select Write Cache Setting and press <Enter>.
Select Enable to enable the Drive Write Cache and improve I/O performance.
●
Select Disable to disable the Drive Write Cache and minimize I/O performance.
●
Viewing the PHY connection rate for the Disk
1
Select the device/disk and press <Enter>.
2
Now select Connection Rate and press <Enter>.
3
The PHY connection rate of the device/disk is displayed.
Setting a Bootable Device
1
Select the device you wish to mark as a bootable device and press <Enter>.
2
Now select Set Bootable and press <Enter>.
Select Enable to boot from the device.
●
Select Disable to disable the marked bootable device.
●
Note:
You can set only one
Chapter 7: Configuring the Controller Utility
as a bootable
device device
.
l 36