Sharp GX-X18SCR Installation And Operation Manual page 42

2. Disassemble the air inlet grille
Open the air inlet grille at 45°, raise it and
remove the grille.
3. Disassemble the filter screen
Draw out the filter screen and remove it.
4. Disassemble the air purifying filter
Remove the air purifying filter after
removing the fixed screws on it.
5. Clean the filter screen
Clean the fil ter screen by a vacuum cleaner
or wash it by flashing water. If the oil stain
on the filter can not be removed or cleaned
up, wash it by warm water meld with the
detergent. Dry the filter in the shadow.
Note:
Never use hot water over 45°C in case of
color fading or turning yellow.
Never dry it by fire so as to prevent the filter
caught fire or deformation.
6. Reset the filter
7. Install the grille well
DC Inverter Cassette Type Unit
Filter screen
Filtering element
Support
Bolt
The same as step 3
The same as step 1 and 2
37