Sharp GX-X18SCR Installation And Operation Manual page 37

● Press this button to set up the swing angle, which circularly changes as below:
● When the guide louver starts to swing up and down, if SWING funtions
SWING
6
UP/DOWN ●
button
● By pressing this button, the clock is allowed to be set, with
CLOCK
7
button
● When TIMER ON is activated, ON will blink while the symbol
TIMER ON
8
button
● Pressing this button can activate or deactivate the X-FAN function.
X-FAN
9
button
is canceled, the air guide louver will stop and remains at the current
position.
indicates the guide louver swings up and down among those five
directions.(Simplified SWING function applicable for some Fan Coil Units:
When the wireless remote controller is energized initially with the unit
under the OFF status, it should be set by pressing the + button and the
SWING button simultaneously, with the symbol
after the unit is turned on, this function can be activated by pressing the
SWING button, with the displayed symbol
on and without this displayed symbol indicating swing function is off.)
and then press the +/- button to adjust the clock within 5 seconds. If the
+/-button is pressed down constantly for more than 2 seconds, the clock
setting will be increased or decreased 10 minutes every 0.5 seconds.
After that, another press on the CLOCK button accepts the setting. 12:00
is the default, when the wireless remote controller is energized.
disappear. Within 5 seconds it is allowed to set the ON time by pressing
the +/- button. Each press will make the time increase or decrease one
minute. Besides, the time can also be set by pressing the +/- button
constantly. that is, in the early 2.5 seconds, the time will increase/
decrease quickly per single minute, and in the late 2.5, the time will
increase/decrease per ten minutes. After the desired time value is set,
press TIMER ON again to conform the setting within five seconds.
After that, another press on TIMER ON will cancel the setting. Prior
to this setting, the clock shall be set to the actual time.
In Cool or Dry mode, by pressing this button,if "
indicates the X-FAN function is activated. By repressing this button,
if " " disappears, it indicates the X-FAN function is deactivated. After
energization, X-FAN OFF is defaulted. If the unit is turned off, X-FAN can
be deactivated but can't be activated.
DC Inverter Cassette Type Unit
32
blinking twice. Then,
indicating swing function is
blinking,
" is displayed, it
will