Table of Contents
Advertisement
REAR LIGHT BAR ASSEMBLY
8. Mount junction box on the back left side of center plate (See Fig. 2), using the fasteners
provided (See Fig. 3).
9. Route all wire harnesses into the junction box. Wire harnesses must enter the junction box
through a compression fitting (Based on the size of the wire harness, choose a
compression fitting with an appropriately sized grommet). Make wiring connections in
junction box with wire harness from truck cab as indicated on wiring diagram (See Fig.4).
1800 NE Broadway Avenue, Des Moines, Iowa, U.S.A. 50313-2644
Phone: (515) 266-3042 • Fax: (515) 313-4426 • Toll Free: (888) 767-8000
E-Mail: sales@swaploader.net • Web Site: www.swaploader.com
(51H68)
ADDITIONAL NOTES:
Prior to any welding, consult the truck
manufacture for any special precautions
that may need to be taken. Typically the
batteries must be disconnected and the
ground lead from the welder should be
as close to the part being welded to
avoid the possibility of arcing across
bearings, gears, etc.
FIG. 3
10/05/09
Advertisement
Table of Contents
