Table of Contents
Advertisement
2.
There are three types of mount brackets used on the Model SL-406 hoist as indicated in
Figure B or Drawing No. 43H31. They are the spring mount brackets (40H31), and the
front mount brackets (Pt. No. 81H23), and the rear mount brackets (Pt. No. 81H24).
Locate the mount brackets on the side of the hoist as indicated in Figure B. These
dimensions are flexible because of possible interference with chassis components. Also
allow for mounting the control valve assembly and the hydraulic tank. You should
consult the truck chassis supplier for any limitations regarding drilling mount holes in the
truck chassis frame rails. Typically, the holes must be at least 2 ¾" from the top of the
truck chassis rails (Reference figure C, D, & E).
Once the locations of the mount brackets have been determined, use the mount brackets
as a template for marking the mounting holes in the truck chassis frame rails. Drill the
21/32 diameter holes required and attach the brackets to the truck chassis with the 5/8-
inch diameter bolts, washers, and locking hex nuts provided. Torque to 220 ft.lbs.
SL-406.INS
09/2009
Figure B
2-3
Advertisement
Table of Contents
