Table of Contents
Advertisement
REAR LIGHT BAR ASSEMBLY
Review all directions and diagrams provided before starting rear light bar installation.
1.
2. Trim truck frame to indicated dimensions (See Fig. 1). This step may have already been
preformed if a bumper was previously installed.
3. Position center plate [Part No. 63H08] on the rear of the main frame. Weld center plate to truck
frame (See Fig. 2 & Additional Notes).
4. Position stub light bar weldment [Part No. 51H69] on truck frame. Stub light bar weldment
should be as high and as far back as possible on the truck frame to avoid interference with
the bumper and fenders. It may be necessary to modify the stub light bar weldment to
avoid interference. Drill mounting holes as required and mount using fasteners provided
(See Fig. 3).
5. Attach the tail light module to the stub light bar weldments with the fasteners provided (See Fig
3).
6. Mount the identification light bar at top center of the center plate [Part No. 63H08] using the
fasteners provided (See Fig. 3).
7. Mount license lamp right of the license plate (See Fig. 2) using the fasteners provided (See Fig.
3).
FIG. 1
(51H68)
INSTALLATION INSTRUCTIONS
I N D E N T I F I C A T I O N
L I G H T R A I L
All Figures are for Illustration Purposes Only
T R U C K F R A M E
( R E F )
C E N T E R
T A IL L I G H T M O D U L E
FIG. 2
C E N T E R
P L A T E
L I C E N S E
L A M P
L I C E N S E P L A T E
(R E F )
J U N C T IO N B O X
( B E Y O N D )
10/05/09
Advertisement
Table of Contents
