Table of Contents
Advertisement
I
. INTRODUCTION
Thank you for purchasing the Panasonic Assembly Qualifier. The AQ Wireless can
monitor battery tools. In its simplest form, the AQ Wireless is configured to monitor a
tool while it's running, determine if the fastening process was successful, report the
status of the fastening, and perform counting functions.
How to Use This Manual
• Please read this manual completely before starting to use your AQ Wireless. If this unit
is mishandled a fatal accident, bodily injury, or damage to the AQ Wireless may occur.
• This manual is intended to be a general guide to the operations of the AQ Wireless.
If any additional questions or concerns arise, please contact a Panasonic Electric
Works Power Tools representative.
• Please keep this manual for future reference. It contains important safety information
that you must follow to use the AQ Wireless safety.
WARNING!
• Do not disassemble the unit for repair or modifications. There is a high electrical
voltage inside the unit that could cause electric shock.
• Do not allow any type of liquid to come into contact with any part of the unit.
• Immediately discontinue use of the unit if smoke, an abnormal odor, or an unusual
sound is detected coming from the unit.
• Insert all fittings fully into their mating receptacles. Failure to do so could result in injury.
• Do not fold, bend or apply excessive force to any cable or fitting.
CAUTION!
• This unit accepts an AC input voltage from 90VAC to 64VAC. Trying to operate this
unit with a voltage outside that range may cause damage to the unit.
• Reception reliability may vary with site conditions. Be sure to verify proper Assembly
Qualifier operation, including data reception, before starting work. Panasonic is not
responsible for any damage sustained as a result of reception problems.
• Avoid placing or storing this unit in a location where it may become wet or dust covered.
• Do not place or mount this unit in an unstable area.
Dropping this unit may result in personal injury or damage to the unit.
• Before performing any maintenance on the unit, make sure to turn it off and
remove the power plugs.
• There are no user serviceable parts inside the main enclosure of the unit.
• Proper operation is not guaranteed in the event that the Assembly Qualifier has been
modified in any way.
• Always use this Assembly Qualifier with a Panasonic tool. Proper operation is not
guaranteed when used with non-Panasonic tools.
Always turn the Assembly Qualifier's power off when not in use.
- 3 -
Advertisement
Table of Contents
