Table of Contents
Advertisement
CHECK mode, monitoring car parameters
17:13 CHECK
-27
eng
6
15
Button 6
in
(1 sec.)
To recieve information about engine and interior temperature and on-board voltage, press button 6
and hold it for 1 second. To exit this mode shortly press F otherwise it will be exited automatically in
10 seconds.
Event history
HISTORY
00:00
ALARM
21:46
ARM
21:33
ENG STOP
21:15
ENG START
20:55
SETUP
To access event history in the system's memory, press and hold button 6 for 2 second. Nagivate last
48 events using button 6 (forward) and button 4 (back). Events are displayed by showing time of the
evend and flashing corresponding indicators. To exit this mode, press button F, otherwise the mode will
be exited in 60 seconds.
- Listen to the extended event history using a phone.
0
9
*
*
0
9
Remote and automatic engine start
The system allows for remote engine start usinf remote
automatic engine start using preconfigured
be used to heat engine and interior, charge battery or to cool the inerior with air conditioning.
Remote and automatic start can only be used when the system is armed.
If the car has manual transmission, automatic launch will only occur if
function was enabled when the car was arming.
18
o
U
15,7
o
85%
«
»
REMOTE ENGINE START
«
»
function. Remote launch can
AUTOMATIC ENGINE START
«
PROGRAMMED NEUTRAL
Car service and security system Pandora DXL 39 7O
Remote and automatic engine start on automatic transmission cars will only occur, if transmission
selector lever was left in a "P" position.
When using remote and automatic engine start functions, make sure that the car is secured with
handbreak or some other means of fixating the car on a parking position.
While system is in remote and automatic start mode, it keeps performing all security functions save
for shock sensor, which will be disabled. To compensate, motion sensor sensitivity, responsiveness
and range will be increased. If any security zone will be triggered, the engine will be immediately
stoped and alarm mode will be entered. Herewith all engine blockages will be activated.
Programmable neutral procedure
short
press
If you are planning to use remote and automatic engine start on a car with manual transmission,
than before arming you will need to perform following actions:
1. When the engine is running, fixate the car with the handbreak.
2. Turn the key in the ignition lock to the OFF position (while you are doing it the engine should
be running) and take it out of the lock.
3. Leave the car, close the door.
4. Press
will be spinning and security mode status icon
5. The engine will be stopped. Now the system is ready to perform remote and automatic engine
command or
start.
Remote engine start
»
If the system is prepared to remote system start, to execute it press and hold
Sound signal will confirm the command, LCD will show crossed out shock sensor icon
User manual
ON
ACC
OFF
Fixate the car using
a handbreak
The engine will be stopped,
the system is ready
to perform remote start
button to arm the car and lock the doors. On LCD remote the engine operation icon
will lit.
Leave the car, close the door
~~
"Engine stop"
ringtone
for 3 seconds.
and flashing
19
Advertisement
Table of Contents
