Sena AGV ARK Quick Start Manual page 3

ASSEMBLY
Support unit
A. Steer the connection unit wiring (1) through the passage made on the support
unit (2).
B. Place the connection unit (3) in its own place on the support unit, making sure
that the metal contacts (4) are placed to the outside.
C. Cut out the positioning adhesive mask (5) and apply it to the surface of the
shell. The mask is supplied with the support unit, and it includes its own in-
structions (the images shown in this document are intended as reference only).
D. Remove the adhesive from the back of the support unit, then glue it to the hel-
met shell aligning it to the edge (6) of the positioning adhesive mask.
Intercom
E. Hook ARK to the support unit. Execute the action in two steps:
1. Place ARK on the support unit by inserting the engagement pins into the
six seats (7);
2. Push ARK towards the front of the helmet by binding the front tooth (8) to
the support unit. A "click" should confirm a safe engagement.
F. Once the cheek pads have been removed (see the helmet user manual), make
the wiring connections paying attention to the coupling direction of the male
and female pins (9). The black pins connect the earphones, the red pins con-
nect the microphone.
G. Apply the earphones (10) to the polystyrene shell using the supplied adhesive
velcro (11).
H. Apply the microphone (12) to the polystyrene shell (13) using the supplied ad-
hesive velcro (14). Apply the microphone for modular and jet helmets to the
polystyrene surface. Apply the microphone for full-face helmets to the inner
surface of the chin, right in front of the mouth.