Confirm System, Ct And Ut Ratio Settings; Verify System, Ct And Ut Ratio Settings - GARO GNM3T-RS485 Installation And Programming Manual

5

Confirm System, CT and UT Ratio settings

!
!
Rx
!
1. Click right touch area to change to "YES".
2 Press center touch area to confirm the setting.
6

Verify System, CT and UT Ratio settings

The settings for System, CT and UT Ratio is visible step by step. Verify that all values are correct.
When all settings are correct, go to step 7.
!
!
Rx
!
If the settings are incorrect, you can at this stage by pressing center touch area, start the setting process again at step 2. "no" must be
visible.
!
!
Rx
!
!
!
Rx
!
!
!
Rx
!
!
!
Rx
!
EN
9