Ut Ratio Setting - GARO GNM3T-RS485 Installation And Programming Manual

EN
4

UT Ratio setting

NOTE! Correct Ut Ratio value is"1" for 230/400V systems.
Rx
1. Press and hold center touch area until PrG is visible.
2. Click right touch area until wanted value is visible. Confirm by press center touch area and next figure starts to blink.
Repeat until the complete value is correct and "no" is visible.
Rx
3. Click right touch area to change to "YES".
4. Press center touch area to confirm the setting.
8
!
!
!
!
!
!
!
!
Rx
!
!
!
Rx
!