Set/Verify The Baudrate; Set/Verify The Parity And Stopbit - GARO GNM3T-RS485 Installation And Programming Manual

EN
13

Set/verify the Baudrate

NOTE! Correct Value:Baudrate: 9.6
Rx
1. Click left touch area until "bAud" is visible. Default is 9.6 and this is correct.
If you need to change bAud, longpress center touch area and click left or right touch area until 9.6 is visible. Confirm by longpress
center touch area.
14

Set/verify the Parity and stopbit

NOTE! Correct Values:Parity: no Stopbit: 1
Rx
1. Click left touch area until "PArIty" is visible. Default is "no" and this is correct.
If you need to change the parity, longpress center touch area and click left or right touch area until "no" is visible. Confirm by longpress
center touch area.
14
!
!
! ! !
!
!
! ! !
!
!
Rx
!
!
!
Rx
!