Ut Ratio Setting - GARO GNM3T-LP RS485 N Installation And Programming Manual

EN
5

UT Ratio setting

NOTE! Correct Ut Ratio value is "1" for 230/400V systems.
Rx
1. Click left touch area until "Ut rAtIo" is visible.
If you need to change the Ut Ratio value, follow below instructions:
2. Longpress center touch area and PrG is visible.
3. Click left or right touch area until wanted value is visible. Confirm by longpress center touch area and next figure starts to blink.
4. Repeat step 3 until the complete value is correct.
6
Rx Rx Rx
Click left touch area until you see "AddrESS".
8
!
!
! !
!
!
! ! !
!
!
Rx
!
!
!
Rx
!