Handles - Husqvarna 555 Workshop Manual

7.6.2 To do a function test of the start/stop switch
1. Clean the surfaces where you will measure the
resistance.
2. Connect a multimeter to the blue cable and the
cylinder to measure the resistance. The resistance
must not be higher than 0.5 Ω.
Note: The start/stop switch must be in the ON
position to give the correct indication. The start/stop
switch is in the ON position when you hold the
button down.
1540 - 001 -

7.7 Handles

7.7.1 To remove and install the front handle
1. Loosen the screw in the vibration damping system.
2. Remove the 2 screws.
3. Remove the front handle from the product.
4. Install in the opposite sequence.
Repair instructions - 21