Husqvarna 555 Workshop Manual page 29

• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 65 .
• Replace the spark plug if it is necessary.
7.9.3 To remove the ignition system
1. Remove the cylinder cover.
2. Disconnect the spark plug cap from the spark plug.
3. Remove the starter unit. Refer to
the starter unit on page 25 .
4. Remove the spark plug cable from the cooling air
conductor.
5. Remove the cooling air conductor.
1540 - 001 -
6. Pull out the spark plug cable.
Technical data
To disassemble
7. Remove the 2 screws and the ignition module.
8. Disconnect the ignition module.
Repair instructions - 29