Husqvarna 555 Workshop Manual page 27

7.8.3 To assemble the starter unit
WARNING: Use approved eye protection. The
recoil spring can eject and cause injuries.
1. Put a new recoil spring (B) in the starter housing (A).
Attach the spring cassette (C) to the starter housing.
Tighten the 2 screws (D) to the correct torque. Refer
Servicing data on page 7 .
to
2. Push the end of the starter rope into the hole in the
starter pulley. Use a pointed pliers to pull out the
starter rope from the starter pulley. Make a knot at
the end of the starter rope.
1540 - 001 -
3. Pull the starter rope through the hole in the starter
housing.
4. Pull the starter rope through the starter rope handle
and make a knot.
5. Put the starter pulley in the starter housing and
tighten the screw.
D
C
B
A
6. Pull the starter rope up into the notch in the starter
pulley. Use your thumb and turn the starter pulley 3
turns clockwise to wind the starter rope on the
starter pulley. Make sure that you can turn the
starter pulley ½ turn more when you pull out the
starter rope fully.
Repair instructions - 27