Table of Contents
Advertisement
2-1. Removal from Rack
w
Never pull out two or more units at a time.
If two or more units are pulled out, the rack falls down in
under the weight of the units. This may cause a serious
injury.
c
• Be sure to pull out the unit with two-person or more.
Trying to handle this job by a one-person could lead to
injury.
• Be sure to handle this job carefully keeping in balance.
If you lose your balance, the unit will be dropped. This
may cause a injury.
• Be careful not to get caught your hand and finger in the
rack mount rail.
<Procedure>
1. Turn the power off.
2. Disconnect all cables from the connector panel.
3. Remove the four rack mounting screws and washers.
4. Pull the rack angles toward you.
Rack
Rack angle
Washer
X
RK5
16
DME-3000/7000
RK5
n
When the unit is mounted in the rack, refer to steps 5
through 7 in section 1-6.
Section 2
DME-3000/7000 Service Overview
Rack angle
Washer
X
16
2-2. Removal of Cabinet
Opening/Closing and Removal of Front Panel
1. Loosen the locking screw on the front panel using a
flat-blade screwdriver.
2. Pull the locking screw toward you and open the front
panel.
Front panel
3. Push the hinge pin in the direction of the arrows while
holding the front panel, then remove the front panel.
Front panel
Hinge pin
Locking screw
2-1 (E)
Advertisement
Table of Contents
