Related Manuals for Sony BKMA-506
Summary of Contents for Sony BKMA-506
- Page 1 DDR CONTROL PANEL CASE KIT BKMA-506 INSTALLATION MANUAL 1st Edition (Revised 1) Serial No. 10001 and Higher...
- Page 2 Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. BKMA-506...
-
Page 3: Table Of Contents
Installation Space .................. 1-1 (E) 1-3. Installing the Control Panel ..............1-2 (E) 1-4. Installing the Console ................1-4 (E) 2. Service Overview 2-1. Specifications ..................2-1 (E) 2-2. List of Periodic Replacement Parts ............2-1 (E) 1 (E) BKMA-506... -
Page 5: Manual Structure
Manual Structure Purpose of this manual This manual is the installation manual of the BKMA-506 DDR Control Panel Case Kit. This manual is intended for use by trained system and service engineers, and describes the information regarding installation. Related manuals Besides this Installation Manual, the following manuals are available for the BKMA-506. -
Page 7: Installation
Installation 1-1. Overview The BKMA-506 is the DDR control panel case kit in which the disk recorder control panel BKMA-505 is housed. The disk recorder control panel BKMA-505 can control the multi access disk recorder MAV- 555/555A/555SS from a remote location when it is connected to the MAV-555/555A/555SS. At the same time, the BKMA-506 enables the MAV-777 to be controlled from a remote location by installing the control panel supplied with the multi access video disk recorder MAV-777. -
Page 8: Installing The Control Panel
6. Attach the nine screws (B3 x 6) in the order shown B3 x 6 below. 2. Loosen the two coin screws. 3. Connect the cable of the control panel. Route the cable so that it will not contact the fan. Coin screw Coin screw Control panel 1-2 (E) BKMA-506... - Page 9 . Connecting when the control panel is attached Use the MAV-555/555A/555SS/777 while the control pan- B4 x 8 el is opened. Be careful not to catch the connection cord. Notch Connection cord Blank panel Connection cord Connection cord Connector Connection cord 1-3 (E) BKMA-506...
-
Page 10: Installing The Console
When three or more pads are necessary, place an order (Sony part number : 7-682-377-04) separately. Pad : Sony part cord No. : 3-624-891-01 (1 piece) 11. Attach the two rubber feet with the two screws (PS 4 x 14). - Page 11 (RK5 x 14) and the four ornamental washers. (RK5 x 14) and the four ornamental washers. Make a space of 1U (43.6 mm) or more behind the Make a space of 1U (43.6 mm) or more behind the BKMA-506. BKMA-506. Ornamental washers Ornamental washers...
- Page 12 4-7 x 10 slot 78.5 ±0.5 161.5 ±0.5 <In case of attaching the panel without any slant angle> 438 ±0.5 _0.5 465 ±0.5 4-7 x 10 slot 427 ±0.5 *Tolerance of dimensions is ± 0.3 mm unless otherwise specified. 1-6 (E) BKMA-506...
-
Page 13: Service Overview
Section 2 Service Overview 2-1. Specifications BKMA-506 General +5 dC to +40 dC Operating temperature _20 dC to +60 dC Storage temperature Operating humidity 20% to 90% 424 x 175.2 x 114.4 (w/d/h) (not including protrusions) External dimensions inches) Mass Approx. - Page 15 The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...
- Page 16 Printed in Japan Sony Corporation BKMA-506 (SY) J, E 2002. 1 16 B&P Company 3-203-686-02 ©1999...