X-431 V Protection Sleeve; Dbscar Diagnostic Connector - Launch X-431 V User Manual

Hide thumbs Also See for X-431 V:

Table of Contents

LAUNCH

USB port

Microphone

1.3.3 X-431 V Protection Sleeve

Dismantling X-431 V protection sleeve

To remove protection sleeve from X-431 V main unit, follow the steps described

as below to proceed:

1. Pull the red sleeve outwards from the right margin of X-431 V, and then

remove it completely.

2. Reverse the upper enclosure and then use the screwdriver to loosen all

screws.

3. Take out the lower enclosure from the upper enclosure.

4. Finally remove X-431 V tablet computer from the upper enclosure.

Note: Reverse the above-mentioned steps to install X-431 V protection sleeve.

While mounting it, please pay more attention to the installation direction.

①

OBD-16

connector

②

Power indicator

X-431 V User's Manual — Knowledge of X-431 V

Fig. 1-3 DBScar diagnostic connector

diagnostic

To connect to vehicle's OBD2

DLC.

It lights up while plugging the

DBScar

connector

vehicle's DLC.

into

the

Table of Contents