LOXONE Nano Motor Controller Air Quick Start Manual

Connection cable (Output)
Wire cross-section
1.5mm² / AWG 18
Stripping length
10mm / 0.4"
Cable length 150mm / 5.91"
min. 80°C / 176°F for IEC,
Temperature resistance
min. 75°C / 167°F for UL
Power supply
Wire cross-section 0.75 ... 2.5mm² / AWG18 ... 13
Stripping length 5mm / 0.2"
Torque of terminal blocks 0.35 ... 0.4Nm / 0.26 ... 0.3 lbf ft
Temperature resistance -40 ... 105°C / -40 ... 221°F
Installation
The installation of this device has to be carried out by a
qualified person. The device has to be fitted in accordance with
building regulations for electrical and fire safety. If the device is
not installed according to manufacturers guidelines the
protection of the device may be affected.
Information
Contains FCC ID: 2ARRV-000375
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
This folder is a part of the product!
For additional information, declaration of confirmity,
visit loxone.com/help/nano-motor-controller-air
Need Help?
loxone.com/support
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com
Nano Motor
Controller
Air
Part No: 100472