Ip Address; Setting With Dip Switches; Table 8 Meaning Of The Dip Switch S101; Table 9 Values For The Individual Dip Switches - Beckhoff CX8190 Manual

Configuration
6.2

IP address

6.2.1

Setting with DIP switches

You can set the IP address for the switched Ethernet interfaces X101/X102 with the DIP switches S101. The
DIP switches have no meaning for the Ethernet interface X001.
Fig. 8: DIP switch S101, switches 1 to 10.
Right switch position: on "1".
Left switch position: off "0".
You can edit the last byte of the IP address with DIP switches 1 to 8. The DIP switches take priority over the
settings in the operating system. The changes are only accepted after restarting the Embedded PC.
Table 8: Meaning of the DIP switch S101.
DIP switch S101
10 on and 9 off.
10 off and 9 off.
10 off and 9 off
1 to 8 all on
Example
If you wish to set the IP address for the Ethernet interface X101/X102 to 192.168.1.67 using the DIP
switches, you have to configure the DIP switches as follows:
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6 DIP 7 DIP 8 DIP 9 DIP 10
On On Off
The following value for the last byte of the IP address then results from the switched-on DIP switches:
0 1 6
2 + 2 + 2 = 67
Table 9: Values for the individual DIP switches.
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6 DIP 7 DIP 8
0 1
Value 2 2
30
Meaning
DHCP active. Standard setting ex factory.
The DIP switches 1 to 8 then have no meaning.
DHCP inactive.
The fixed IP address 192.168.1.xxx and subnet mask 255.255.255.0
are used as standard.
The last byte of the IP address 192.168.1.xxx is edited with DIP
switches 1 to 8.
You can change the first three bytes of the IP address in the operating
system [} 31] or via the web interface (Beckhoff Device Manager)
[} 34]. You can edit the last byte of the IP address again with the DIP
switches.
The complete IP address is adopted from the operating system or the
web interface (Beckhoff Device Manager).
Off Off Off
2 3 4
2 2 2
On Off off
5 6 7
2 2 2
Version: 1.5
off
CX8190