Structure; Table 2 Legend For The Configuration; Fig. 1 Sample Configuration Of A Cx8190 Embedded Pc - Beckhoff CX8190 Manual

4.1

Structure

7
6
5
4
3
2
1
Fig. 1: Sample configuration of a CX8190 Embedded PC.
Table 2: Legend for the configuration.
No. Component
1
DIP switch [} 30] (S101).
2
Battery compartment
[} 63] (under the front
flap).
3
MicroSD card slot [} 18]
(under the front flap).
4
Ethernet interfaces RJ45
[} 15] (X101, X102).
5
Reset button [} 18]
6
Diagnostic LEDs [} 59].
7
Ethernet interface [} 15]
(X001).
8
Diagnostic LEDs, power
supply terminal [} 59].
9 Spring-loaded terminals,
+24 V and 0 V
10 Terminal bus (K-bus or E-
bus)
11 Spring-loaded terminal,
+24 V
12 Spring-loaded terminal, 0 V Power supply for Bus Terminals via power contact.
13 Terminal release
14 Spring-loaded terminal, PE Spring-loaded terminal for power contact PE.
15 Power contacts, +24 V,
0 V, PE
Also see about this
2 Setting with DIP switches [} 30]
CX8190
8
9
10
11
12
13
14
15
Description
You can set the IP address for the X101/X102 switched Ethernet
interfaces with the DIP switch.
Power supply for the battery-backed clock for time and date.
Slot for industrial MicroSD cards.
For the connection to local networks. Realtime-Ethernet-capable.
This switches the Embedded PC to Config mode.
Diagnostic LEDs. You can create your own diagnostic messages
for the WD and ERR diagnostic LEDs (see: Control diagnostic
LEDs [} 51]).
Interface for commissioning and programming the Embedded PC.
Diagnosis of the power supply for the Embedded PC and the
terminal bus. Status of the E-bus and K-bus communication.
Power supply for Embedded PC.
Interface for EtherCAT Terminals or Bus Terminals. Data exchange
and supply.
Power supply for Bus Terminals via power contact.
Releases the power supply terminal and therefore the Embedded
PC from the mounting rail.
Power contacts for Bus Terminals.
Version: 1.5
Product overview
10
13