Table of Contents
Advertisement
3)
Press the <MEMORY VIEWER/USB DISPLAY/NETWORK> button on the remote control to switch to
Network input.
f The network input idle screen is displayed. The login password (a four-digit number that is automatically generated),
projector name: PROJECTOR (fixed), IP address (Wireless LAN) and IP address (Wired LAN) will be displayed in the
idle screen.
f You can also press the <INPUT/ENTER> button on the control panel and the input source screen is displayed, then
press as to select [Network].
f LOGIN PASSWORD
f PROJECTOR NAME
f IP ADDRESS(WIRELESS)
f IP ADDRESS(WIRED)
Attention
f Please do not move or transport the projector while the wireless module is attached. Doing so may cause the wireless
module to be damaged.
f The blue LED of the wireless module will be off when the projector is in standby mode, it will light when the power is turned
on and it will blink during wireless communicating.
Please do not remove the wireless module while the LED is blinking.
f When executing an invalid operation during network input, the icon
displayed. In this case, press the <MENU> button and execute each function from the menu operation.
Note
f The projector name is fixed as "PROJECTOR" and cannot be changed.
f Wireless LAN and wired LAN cannot be used in the same segment.
f The settings of the wireless module are as follows:
Computer setting
1)
Turn on the computer.
2)
Make the network setting according to your system administrator.
f Please make the network settings for the computer and the projector according to your system administrator.
3)
Connect to the network that has been set in the projector.
f If you use a computer, click on the task tray
[SSID] that has been set in the projector.
f Please confirm [SSID] in the [Expand] menu → [Network] → [Network information] of this projector.
Note
f If you use any wireless LAN connection utility that meets the OS standard, follow the operation instruction of the utility to
connect it.
80 - ENGLISH
Chapter 5 Operation of Function - Network connection
Wireless module of optional accessories
(Model No.: ET-WML100)
LED
[SSID]
[Channel]
[IP address]
[Subnet]
[Gateway]
[Access point Encryption]
(bottom right of the computer), then select the same name as the
Network input idle screen
LOGIN PASSWORD :
5678
PROJECTOR NAME :
PROJECTOR
IP ADDRESS(WIRELESS) :
172.28.120.1
IP ADDRESS(WIRED) :
192.168.1.100
that indicates the key operation is invalid will be
NetworkDisplay
1
172.28.120.1
255.255.255.0
0.0.0.0
None
Advertisement
Table of Contents
