Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
3)
Press as to switch the item.
f The items will switch each time you press the button.
[Logo select]
[Capture]
[Logo PIN code
lock]
[Logo PIN code
change]
[Logo select]
Select the logo to be displayed at projector start-up.
1)
Press as to select [Logo].
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
3)
Press as to select [Logo select].
4)
Press the <ENTER> button.
5)
Press as to switch the item.
f The items will switch each time you press the button.
[Off]
[Default]
[User]
*1
*1 [User] will be unavailable when no user logo is registered.
Note
f [Logo Select] cannot be set if [Logo PIN code lock] is set to [On].
[Capture]
Register the user logo to be displayed at projector start-up.
1)
Press as to select [Logo].
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
3)
Press as to select [Capture].
f Display the image you want to project at projector start-up.
4)
Press the <ENTER> button.
5)
A confirmation screen is displayed, press as to select [Yes] and then press the <ENTER> button.
f The captured image is registered as a user logo on this projector.
f After capturing the image, the [Logo select] is set to [User]. The user logo will be displayed when the projector starts up
next time.
Note
f Only supports still image-based computer (RGB) and still image-based HDMI signals input.
f Capture may not be available depending on the input signal.
f It is recommended to capture the same resolution signal as the display dots (panel resolution) of the projector.
For PT-TW371RD: 1 280 x 800
f [Capture] cannot be set if [Logo PIN code lock] is set to [On].
f The correction state of the [Keystone] will be canceled temporarily when the image is being captured.
Chapter 4 Settings - [Expand] menu
Select the logo to be displayed at projector start-up.
Register the user logo. The projected image will be captured and used as a logo to be displayed at
projector start-up.
Prevent the logo from being changed by any person other than the administrator by setting a
three-digit Logo PIN code.
Change the Logo PIN code.
Displays only the countdown at projector start-up.
Displays the Panasonic logo and the countdown at projector start-up.
Displays only the image registered by the user at projector start-up.
ENGLISH - 63
Advertisement
Table of Contents
