Table of Contents
Advertisement
[Display] menu
On the menu screen, select [Display] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 44) for the operation of the menu screen.
[Auto PC adj.]
(Only for still image signals input)
When the still image analog RGB signal is input, the image may flicker or shift up, down, left or right. In such a case, press the
<AUTO SETUP> button to automatically adjust [Fine sync], [H Position], [V Position] and [H.Size] to an optimal state. Perform
this function to achieve an optimal state that matches the image.
1)
Press as to select [Auto PC adj.].
2)
Press the <ENTER> button.
f [Please wait] screen is displayed, the Auto PC adj. function will be executed.
Note
f The projector executes the Auto PC adj. automatically when detecting image signals that are input to the projector for the
first time.
f Automatic adjustment may not work depending on the model of the computer and the input signal.
f The [Auto PC adj.] cannot be operated when 720 x 480i, 720 x 576i, 720 x 480p, 720 x 576p, 1280 x 720p, 1920 x 1080i or
1920 x 1080p is displayed in the [Display] menu → [System], or when the digital signal is input.
[Fine sync]
(Only for analog RGB signals)
You can adjust the clock phase to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [Fine sync].
2)
Press the <ENTER> button.
3)
Press as to adjust the level.
f The adjustment values are 0 to +31. Adjust so that the amount of interference is at a minimum.
Note
f Certain signals may not be adjustable.
f Optimal value may not be achieved if the output from the input computer is unstable.
f To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [Fine sync] is adjusted.
f [Fine sync] cannot be adjusted when a digital signal is input.
[H Position]
(Only for still image signals input)
Adjust the image position if the image projected on the screen is shifted left or right even when the positions of the projector
and screen are correct.
1)
Press as to select [H Position].
2)
Press the <ENTER> button.
3)
Press as to adjust the horizontal image position.
Orientation
Horizontal (left and
right) adjustment.
Note
f [H Position] is not available while the image is expanded in the digital zoom function.
48 - ENGLISH
Chapter 4 Settings - [Display] menu
Operation
Press the a button. The image position moves to the right.
Press the s button. The image position moves to the left.
Adjustment
Advertisement
Table of Contents
