Raider Pro User Manual page 9

1. Charger information and charging process.
1.1. Please see the data on the charger label. Make sure you connect the charger to the power supply with the voltage
indicated on the nameplate. Never connect the charger to a network of different voltages.
1.2. Protect the charger and its cable from damage and sharp edges. Damaged cables must be repaired immediately
by a qualified electrician.
1.3. Keep the charger out of the reach of children.
1.4. Do not use damaged chargers.
1.5. Do not use the supplied charger to charge other rechargeable batteries.
1.6. The present charger is not intended for use by persons (including children) with limited physical, sensory or mental
capabilities, or for persons without experience and knowledge of the equipment unless the use is monitored or in accordance
with the instruction manual for the device transmitted by persons responsible for safety. Care must be taken not to play with
equipment.
1.7. The charger must not be exposed to moisture or water. The entry of water into the charger increases the risk of
electric shock. The charger can only be used indoors in dry rooms.
1.8. Before carrying out any maintenance or cleaning of the charger, you must disconnect the charger from the power
supply.
1.9. Do not use the charger on a flammable substrate (eg paper, cloth) or near flammable substances. Due to the
charging of the charger in the charging process, there is a risk of fire.
1.10. Check the status of the charger, cable, and plug before each use. In the event of faults, do not use the charger. Do
not attempt to disassemble the charger. All repairs should be assigned to an authorized repairer. Incorrect installation of the
charger may result in electric shock or fire.
1.11. When the charger is not in use, it must be disconnected from the mains.
1.19. It is forbidden to repair a damaged charger. Carrying out the repair of the charger is only permitted by the
manufacturer or an authorized workshop.
2. Charging a lithium-ion rechargeable battery with the charger.
Remove the rechargeable battery from the machine by pressing the button. Pay attention to mains voltage when
charging the battery! The mains voltage must match the data on the charger label. Appliances marked with 230 V can also
be powered with a voltage of 220 V.
Plug the plug into the socket. The green LED will light up. Put the depleted rechargeable battery into the charger. the red
LED will illuminate. Once the battery is charged, the red LED will go off and will turn green.
See explanation table:
Red LED
Off
On
Off
Green LED
On
ready for use; there is no
Off
On
Disconnect the charger from
Explanations and actions
Ready for use
The charger is connected to the mains and is
battery pack in the charger
Charging
The charger is charging the battery pack
The battery is charged and ready for use.
Action:
Take the battery pack out of the charger.
the mains supply.
9