Realtree RTLS-310 Instruction & Safety Manual page 12

Installation Instructions Page 2
6
R
L
Tie one end of Tiedown Rope
to the inner part of Stabilizer Bar
6
L
near the flanged end. Wrap the
rope around the back of the tree
once. Then tie the other end of
the rope to the Stabilizer Bar
9
T
DETAILED BUCKLE STRAP INSTRUCTIONS
1
Hold buckle as shown.
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
7
S
R
Cross Installation Straps
behind tree. Attach to the top
7
rung of the bottom ladder section.
Pull to tighten the straps against
the tree. (See Installation Strap
L
.
Instructions).
Before sitting down IMMEDIATELY wrap the strap
9
T
of the Ratchet Strap
once and thread through the ratchet. (See Details
Ratchet Instructions Below).
W A R N I N G
2
Press down on latch and
insert strap underneath
teeth as shown.
S
around the back of the tree
DO NOT climb ladder without Stabilizer Bar and Installation Straps installed. Serious
injury or death may occur if Stabilizer Bar and Installation Straps are not installed.
3
Pull strap to desired length.
Model: RTLS-310
15' Ladderstand
8
After the ladder stand has been
secured to the tree with the installation
straps, and the stabilizer bar has been
securely attached to the tree, continue
8
to have two people hold the ladder,
climb cautiously up to the platform.
Once you reach the top,
IMMEDIATELY ATTACH YOUR
SAFETY HARNESS TO THE TREE.
Keep the tether strap above our head.
4
Pull slack to tighten.
©2021 (rev. 1/21)