Stihl HSE 42 Instruction Manual page 6

English
To reduce the risk of stumbling,
–
position and clearly mark the
connecting cable so that it cannot
be damaged or endanger others.
The trigger switch lockout, trigger
–
switch and switch lever must move
freely and return to the idle position
when they are released.
Cutting blades must be properly
–
tightened and in safe operating
condition (clean, sharp, not bent or
warped), correctly mounted and
thoroughly sprayed with STIHL
resin solvent (lubricant).
Check cutter guard (if fitted) for
–
damage
Never attempt to modify the controls
–
or safety devices.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the machine.
To reduce the risk of accidents and
personal injury, do not operate your
power tool if it is not properly assembled
and in good condition!
To reduce the risk of electric shock:
Always connect the engine analyzer
–
to a properly installed wall outlet.
Any extension cords used must
–
comply with the specifications for
the particular application
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition
4
Holding and Guiding the Machine
Always hold the unit firmly with both
hands on the handles. Wrap your fingers
and thumbs around the handles.
Right-handed users
Right hand on the control handle and left
hand on the loop handle.
Left-handed users
Left hand on the control handle and right
hand on the loop handle.
Make sure you have a firm and secure
footing and hold the unit so that the
cutting blades are always away from
your body.
While working
In case of imminent danger or in an
emergency, switch off the motor
immediately – release the trigger switch
and switch lever.
Ensure that there are no other people
within the working area.
Watch the cutting blades at all times – do
not cut areas of the hedge that you
cannot see.
Be extremely careful when cutting tall
hedges; check the other side of the
hedge before starting work.
The drive motor is not
waterproof. To reduce
the risk of a short circuit
or electrocution, never
work with the power tool
in the rain or in wet or
very damp locations.
Do not leave the power tool outdoors in
the rain.
Your power tool is equipped with a
system designed to quickly stop the
cutting blades – they come to an
immediate standstill as soon as you
release the trigger switch or the switch
lever.
Check this function at regular, frequent
intervals. Do not operate the machine if
the cutting blades continue to run after
switching off – risk of injury! Contact your
servicing dealer.
Take special care in slippery conditions
– damp, snow, ice, on slopes or uneven
ground!
Clear away fallen branches, scrub and
cuttings.
HSE 42, HSE 52