Husqvarna K 1260 Workshop Manual page 52

5
1
2
4
6
HANDLE
3
5
5. Fit the shaft from the right side of the machine, as seen
from behind. Knock in the shaft with a pin punch and a
small hammer.
Fit the throttle lock
1. Position the spring loop in the slot for this in the
throttle, as shown in the divided handle to the right.
2. Press the throttle lock down in the lower part of the
handle.
3. Press the throttle lock in the upper part of the handle.
It will be locked in position by the throttle.
4. Fit the lower shaft for the throttle lock.
5. Fit the upper shaft for the throttle lock. By pulling
the throttle wire, the lever arm will come into the correct
position for fitting the shaft.
6. Knock in the shafts with a pin punch and small hammer
so that they do not protrude beyond the handle on either
side.
18
52