Husqvarna K 1260 Workshop Manual page 51

18
1
3
51
HANDLE
2
4
Throttle lock
Press in the throttle in the handle top. Press the throttle
forwards with a screwdriver and lift up the rear edge.
Pull the throttle from the handle.
Removed throttle lock.
Important
If the white lever for the throttle wire is not included, as
shown below, it can be pressed with a screwdriver as shown
in the adjacent pictures. (The picture to the right shows a
divided handle.)
Throttle
Pull up the throttle until it stops.
Raise the white lever for the throttle wire and place it in the
position shown.
Press the unit at a slight angle to the side, as shown, and at
the same time work out the handle. Relatively strong force
is needed.
Removed throttle.
Installing the throttle
1. Fit the throttle wire to the throttle.
2. Put the throttle in place with the white lever up. Slide the
unit in a little.
3. Fold in the white lever in the notch on the throttle.
4. Press the unit completely in position for fitting of the
shaft.