6.3 CTCSS scanning
The function allows to scan the frequencies with CTCSS tone enabled.
a. In standby mode, press [MENU] [2][9], "Scan CTCSS" will appear on the display.
b. Press [MENU] and the scan of CTCSS tones will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.4 DCS scanning
This function allows to scan the frequencies with DCS code enabled.
a. In standby mode, press [MENU] [3][0]; the display will show "Scan DCS".
b. Press [MENU] and the scan of DCS codes will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.5 Cursor▼▲Conversion (A/B)
Directly press [Back] key to move the cursor up and down. Then, you can modify or confirm the parameters indicated by the
cursor.
Important1: P10UV has a dual-frequency display function. In frequency mode, you will see on the display two different
receiving and transmitting frequencies; while in channel mode the two different channels will be displayed.
Important2: In frequency or channel mode, press the [Back] key to shift between the main channel A and the sub-channel B
▲ on the display indicates on which channel (main channel A or sub channel B) you are operating.
▼ is displayed next to the channel.
6.6 Keypad lock
To avoid accidentally changing the radio setting, press the [* ] button for 2 seconds. The
icon will appear on the display.
PTT, MONITOR, and LAMP buttons will still be active. Repeat the same procedure to unlock the keypad.
18