Table of Contents
Advertisement
Visit Radioddity.com For Downloads And Help
Scanning a Frequency Range (VFO Mode)
The UV-5RX3 can scan a user selected frequency range
Procedure 5.2.Settingscanning range
1. Press and Hold
for about 2 seconds
2. The Radio will begin to scan the frequency
Scanning Your Selected Channels (Channel Mode)
The UV-5RX3 can scan your programmed memory channels; you can easily add or
remove channels from the scanning bank at any time
Procedure 5.3. Scanning channels
1. Press and Hold for about 2 seconds to start scanning
2. Channels with a ★ by the Channel number will be included in the scan cycle
Visit Radioddity.com For Downloads And Help
29
Scanning for CTCSS and DCS Tones/Codes
Scanning for a CTCSS tone or DCS code can be done while Frequency Mode (VFO) or
Channel M ode( MR) is selected .Only when VFO mode is selected, con the detected
tone/code be saved to menu 11/10.
CTCSS tone and DCS code scanning mode can be accessed with or without a
signal being present. The scanning process itself only occurs while o signal is
being received.
Not all repeaters requiring a CTCSS tone or DCS code for access will transmit one
back. In that case, the transmitter of a station that can access the repeater would
need to be scanned. In other words: this would be done by listening to stations on
the repeater's input frequency.
Tone Scanning
30
Advertisement
Table of Contents
